Critical point (thermodynamics)
In physical chemistry, thermodynamics, chemistry and condensed matter physics, a critical point, also called a critical state, specifies the conditions (temperature, pressure and sometimes composition) at which a phase boundary ceases to exist. There are multiple types of critical points such as vapor-liquid critical points and liquid-liquid critical points.
Contents |
Pure substances: vapor-liquid critical point
The term "critical point" is sometimes used to denote specifically the vapor-liquid critical point of a material. The vapor-liquid critical point denotes the conditions above which distinct liquid and gas phases do not exist.
As shown in the pure species phase diagram to the right, this is the point at which the phase boundary between liquid and gas terminates. In water, the critical point occurs at around 647 K (374 °C or 705 °F) and 22.064 MPa (3200 PSIA or 218 atm)[1].
As the critical temperature is approached, the properties of the gas and liquid phases approach one another, resulting in only one phase at the critical point: a homogeneous supercritical fluid. The heat of vaporization is zero at and beyond this critical point, so there is no distinction between the two phases. Above the critical temperature a liquid cannot be formed by an increase in pressure, but with enough pressure a solid may be formed. The critical pressure is the vapor pressure at the critical temperature. On the diagram showing the thermodynamic properties for a given substance, the point at which critical temperature and critical pressure meet is called the critical point of the substance. The critical molar volume is the volume of one mole of material at the critical temperature and pressure.
Critical properties vary from material to material, just as is the case for the melting point and boiling point. Critical properties for many pure substances are readily available in the literature. Obtaining critical properties for mixtures is somewhat more problematic.
Mathematical definition
For pure substances, there is an inflection point in the critical isotherm on a pV diagram. This means that at the critical point:
This relation can be used to evaluate two parameters for an equation of state in terms of the critical properties.
Sometimes a set of reduced properties are defined in terms of the critical properties, i.e.:
where 
is the reduced temperature, 
is the reduced pressure, and 
is the reduced volume.
Principle of corresponding states
Critical variables are useful for rewriting a varied equation of state into one that applies to all materials. The effect is similar to a normalizing constant. The principle of corresponding states indicates that substances at equal reduced pressures and temperatures have equal reduced volumes. This relationship is approximately true for many substances, but becomes increasingly inaccurate for large values of pr
Table of liquid-vapor critical temperature and pressure for selected substances
| Substance[2][3] | Critical temperature | Critical pressure |
|---|---|---|
| Argon | −122.4 °C (151 K) | 48.1 atm (4,870 kPa) |
| Ammonia[4] | 132.4 °C (405.6 K) | 111.3 atm (11,280 kPa) |
| Bromine | 310.8 °C (584.0 K) | 102 atm (10,300 kPa) |
| Caesium | 1,664.85 °C (1,938.00 K) | 94 atm (9,500 kPa) |
| Chlorine | 143.8 °C (417.0 K) | 76.0 atm (7,700 kPa) |
| Fluorine | −128.85 °C (144 K) | 51.5 atm (5,220 kPa) |
| Helium | −267.96 °C (5.19 K) | 2.24 atm (227 kPa) |
| Hydrogen | −239.95 °C (33.2 K) | 12.8 atm (1,300 kPa) |
| Krypton | −63.8 °C (209 K) | 54.3 atm (5,500 kPa) |
| Neon | −228.75 °C (44.4 K) | 27.2 atm (2,760 kPa) |
| Nitrogen | −146.9 °C (126 K) | 33.5 atm (3,390 kPa) |
| Oxygen | −118.6 °C (155 K) | 49.8 atm (5,050 kPa) |
| CO2 | 31.04 °C (304.19 K) | 72.8 atm (7,380 kPa) |
| H2SO4 | 654 °C (927 K) | 45.4 atm (4,600 kPa) |
| Xenon | 16.6 °C (289.8 K) | 57.6 atm (5,840 kPa) |
| Lithium | 2,950 °C (3,220 K) | 652 atm (66,100 kPa) |
| Mercury | 1,476.9 °C (1,750.1 K) | 1,720 atm (174,000 kPa) |
| Sulfur | 1,040.85 °C (1,314.00 K) | 207 atm (21,000 kPa) |
| Iron | 8,227 °C (8,500 K) | |
| Gold | 6,977 °C (7,250 K) | 5,000 atm (510,000 kPa) |
| Aluminium | 7,577 °C (7,850 K) | |
| Water[5][6] | 373.946 °C (647.096 K) | 217.7 atm (22,060 kPa) |
Mixtures: liquid-liquid critical point
The liquid-liquid critical point of a solution denotes the limit of the two-phase region of the phase diagram. In other words, this is the point at which an infinitesimal change in some thermodynamic variable such as temperature or pressure will lead to separation of the mixture into two distinct liquid phases, as shown in the polymer-solvent phase diagram to the right. Such points may also be denoted a critical solution temperature. Two types of liquid-liquid critical points are the upper critical solution temperature, or UCST, which denotes the warmest point at which cooling will induce phase separation, and the lower critical solution temperature, which denotes the coolest point at which heating will induce phase separation.
Mathematical definition
From a theory standpoint, as seen in the figure to the right the liquid-liquid critical point represents the temperature-concentration extremum of the spinodal curve. Thus in a two-component system it must satisfy two conditions. First is the condition of the spinodal curve, which is that the second derivative of the free energy with respect to concentration must equal zero. The second condition is the extremum condition that the third derivative of the free energy with respect to concentration must also equal zero, or that the derivative of the spinodal temperature with respect to concentration must equal zero.
In renormalization group theory
According to renormalization group theory, the defining property of criticality is that the natural length scale characteristic of the structure of the physical system, the so-called correlation length ξ, becomes infinite. There are also lines in phase space along which this happens: these are critical lines.
In equilibrium systems the critical point is reached only by tuning a control parameter precisely. However, in some non-equilibrium systems the critical point is an attractor of the dynamics in a manner that is robust with respect to system parameters, a phenomenon referred to as self-organized criticality.
The critical point is described by a conformal field theory.
See also
- Critical phenomena
- Phase transition
- Scale invariance
- Conformal field theory
- Critical exponents
- Percolation thresholds
- Self-organized criticality
- Triple point
- Supercritical fluid, Supercritical drying, Supercritical water oxidation
- Rushbrooke inequality
- Widom scaling
- Tricritical point
- Joback method, Klincewicz method, Lydersen method (Estimation of critical temperature, pressure, and volume from molecular structure)
- Lower critical solution temperature
- Upper critical solution temperature
Footnotes
- ↑ International Association for the Properties of Water and Steam, 2007.
- ↑ Emsley, John (1991). The Elements ((Second Edition) ed.). Oxford University Press. ISBN 0-19-855818-X.
- ↑ Thermodynamics: An Engineering Approach ((Fourth Edition) ed.). McGraw-Hill. 2002. pp. 824. ISBN 0-07-238332-1.
- ↑ http://www.engineeringtoolbox.com/ammonia-d_971.html
- ↑ International Association for the Properties of Water and Steam, 2007.
- ↑ "Critical Temperature and Pressure". Purdue University. http://www.chem.purdue.edu/gchelp/liquids/critical.html. Retrieved 2006-12-19.
References
- "Revised Release on the IAPWS Industrial Formulation 1997 for the Thermodynamic Properties of Water and Steam" (PDF). International Association for the Properties of Water and Steam. August 2007. http://www.iapws.org/relguide/IF97-Rev.pdf. Retrieved 2009-06-09.
External links
- "Critical points for some common solvents". ProSciTech. Archived from the original on 2008-01-31. http://web.archive.org/web/20080131081956/http://www.proscitech.com.au/catalogue/notes/cpd.htm.
- "Critical Temperature and Pressure". Department of Chemistry. Purdue University. http://www.chem.purdue.edu/gchelp/liquids/critical.html. Retrieved 2006-12-03.
- Hagen Kleinert and Verena Schulte-Frohlinde, Critical Properties of φ4-Theories, World Scientific (Singapur, 2001); Paperback ISBN 981-02-4658-7 (readable online here)
|
|||||||||||||||||||||||||
